Browse Categories by Verbatim autodialer

Case Study: Hampton Water Works Co. and Salisbury Water Supply Co.

Posted by jBrown on Fri, Jul 15, 2011 @ 5:08 PM

Hampton Water Works Co. in New Hampshire and Salisbury Water Supply Co. in Massachusetts use the Verbatim Model VSS-8C Autodialer/Alarm Monitor for 24-hour surveillance of two municipal water distribution facilities. During system upgrades for both plants, workers installed the Verbatim autodialer to take over status and alarm reporting on nights and weekends. The monitor is programmed for 11 areas in the plants, which serve about 11,000 customers during peak summer months when daily water delivery nears 7 million gal. Critical monitoring areas comprise water levels in storage tanks and ope... Continue Reading

Continue ReadingLeave a Comment Share This

Verbatim Video Series Part IV: Recording Voice Messages

Posted by jBrown on Thu, Jul 7, 2011 @ 2:08 PM

Part four in RACO’s six-part video series shows how to record voice messages for the Verbatim autodialer. http://www.youtube.com/watch?v=putZCBe_XH0 Now that you have programmed your alarm system, you can start recording voice messages for alarm conditions. First, you should plan and write down all the messages you will record. Use Worksheet C in the manual to help with this process. Two different messages are used for each contact input: one for normal conditions and one for alarm, or fault, conditions. You can leave the normal condition message set to default. Here’s how y... Continue Reading

Continue ReadingView Comments (1) Share This

Verbatim Video Series Part III: Programming the Alarm System

Posted by jBrown on Tue, Jun 7, 2011 @ 4:23 PM

Part three in RACO’s six-part video series covers programming the Verbatim autodialer’s alarm system. Part A http://www.youtube.com/watch?v=E9vOiC5vC0U Part B http://www.youtube.com/watch?v=d2KKqmOWuWE Now that you have your Verbatim Alarm System, it is time to program your unit. Following are instructions of how to finish the initial setup. 1. Clear and reset the system Turn the unit on and press the program button. This puts the device in program mode. Erase the system memory by dialing 9-3-5-9 and then press the enter button. 2. Phone number programming Now th... Continue Reading

Continue ReadingLeave a Comment Share This
Page 1 of 11