Browse Categories by Product Training

Verbatim Video Series Part IV: Recording Voice Messages

Posted by jBrown on Thu, Jul 7, 2011 @ 2:08 PM

Part four in RACO’s six-part video series shows how to record voice messages for the Verbatim autodialer. http://www.youtube.com/watch?v=putZCBe_XH0 Now that you have programmed your alarm system, you can start recording voice messages for alarm conditions. First, you should plan and write down all the messages you will record. Use Worksheet C in the manual to help with this process. Two different messages are used for each contact input: one for normal conditions and one for alarm, or fault, conditions. You can leave the normal condition message set to default. Here’s how y... Continue Reading

Continue ReadingView Comments (1) Share This

Tip of the Month: Connecting Verbatim Gateway to CompactLogix PLC

Posted by jBrown on Fri, May 20, 2011 @ 12:13 PM

Verbatim Gateway autodialers can be connected via DF1 to any of Allen-Bradley’s CompactLogix family of PLCs, which have a 9 PIN, male RS232 port. The following tips will help you get started. 1. Prepare your equipment: You will need a Verbatim Gateway autodialer and 510VAB-1 cable, supplied by RACO, and a CompactLogix PLC, RS232 cable and RSLogix software, supplied by Allen-Bradley. 2. Set up CompactLogix communications: Launch the RSLogix software, then use the tabs to set up the serial and system protocol. Next, configure the CompactLogix base tags. Map the tags to the SLC platform ... Continue Reading

Continue ReadingView Comments (1) Share This

Verbatim Video Series Part II: Installation

Posted by jBrown on Fri, May 13, 2011 @ 2:12 PM

Part two in RACO’s six-part video series covers installing the Verbatim autodialer. http://www.youtube.com/watch?v=adp0Yk9dmko 1. Choose a mounting location This location must be free from condensing humidity and have temperatures between 20°F and 130°F. The autodialer must be within 5 ft of a standard RJ11 phone jack and a grounded 120-V AC outlet. It is possible to mount Verbatim outdoors with the optional enclosure. An optional heater and thermostat is also available to keep the unit at the proper temperature. 2. Get connected Next, complete all of the autodialer’s wiri... Continue Reading

Continue ReadingLeave a Comment Share This

Verbatim Video Series Part I: Introduction

Posted by jBrown on Thu, Apr 14, 2011 @ 9:02 AM

RACO’s six-part video series introduces the Verbatim autodialer and gives viewers thebasics on installation, programming and installation. http://www.youtube.com/watch?v=WgXtEOvxziU The first installment presents Verbatim and all of its features. The system acts as a remote alarm monitor for remote or unattended facilities. The standard system can monitor four inputs at once, but options are available for up to 32. Verbatim usually monitors sensors like float or limit switches to alert it to alarm conditions, but some inputs can be set just for reporting purposes. When Verbatim sens... Continue Reading

Continue ReadingLeave a Comment Share This
Page 2 of 212